Logo Optigrün

Solar Green Roof
Sun Root - 15°

  • Technical Specifications

    Weight *starting at 120-140 kg/m² or 1.2-1.4 KN/m²
    Layer heightstarting at 80 mm
    Roof pitch0-3° (0-5 %)
    Vegetation formsedum
    Water retention50%
    Discharge coefficient **for 0°: C=0.5–0.4
    for 1-4,5°: C=0.45
    Water storageca. 25 l/m²
    Ecological value
    Maintenance costs
    Cost factor *
    *Depending on the load capacity of the substructure, Optigreen "High Density (HD)" or "Low Density (LD)" substrates can be used. Weight specifications refer to saturated conditions; dry weight is approximately 60 - 70 % of the saturated weight. Wind up-lift protection has to be taken into account.
    **Determined at 0° according to FLL guidelines.
  • Brief Description

    Sedum Shoots

    OPTIGREEN EXTENSIVE SINGLE LAYER SUBSTRATE TYPE M or Extenisve Substrate Type E according to the surrounding roof greening build-up

    OPTIGREEN COMBI INSPECTION CHAMBER
    (NOT SHOWN IN THE DRAWING)

    • Simple control of roof drainage outlets.
    • Extendable in 100 mm increments.
    • Side and top drainage openings.
    • Download Data Sheet

    Photovoltaic module

    • Sizes in between 1600 and 1680 mm (upright) are optimal for the Sun Root 15.
    • Manufacturer freely selectable.

    Optigreen Solar Module Support "Sun Root 15"

    • Easily installable support for solar modules with a height of 1600 to 1680 mm.
    • Download Data Sheet

    OPTIGREEN DRAINAGE BOARD TYPE FKD 25 (25 MM)

    • Rapid discharge of surplus water.
    • Prevents accumulation of water for non-pitched roofs and large drainage lengths.
    • Light-weight build-up with high drainage capacity.
    • Water storage.
    • Download Data Sheet

    OPTIGREEN PROTECTION AND STORAGE FLEECE TYPE RMS 500

    • Protects the roof membrane against damage and stores water.
    • For inverted roofs, use the Optigreen Trickle Protection Mat Type RS instead of the RMS fleece.
    • Download Data Sheet
To the top Print Recommend site